Research work · 2015
Heat of hydration of low-clinker cements
Barbara Klemczak, Maciej Batog
Journal of Thermal Analysis and Calorimetry
Abstract
The hydration heat evolution of low clinker cements is studied in a dependence on the testing method and temperature. Four substitution rates of ordinary Portland cement by ground granulated blast furnace slag or siliceous fly ash were used—10, 30, 50 and 70 %. In all cases, the water/binder ratio of the cement paste was 0.5. The heat evolution and the heat evolution rate were monitored over 72 h with the use of two testing methods. The isothermal measurements were carried out with the use of TAM Air isothermal calorimeter at 20 and 50 °C. The heat evolution was also determined with the use of a semi-adiabatic calorimeter. Part I of the paper presents the results of the experimental tests and discussed the influence of mineral additives on the hydration heat evolution.