Research work · 2013

Decibels

David Wyatt, Mike Tooley

Routledge eBooks

Abstract

A negative result denotes attenuation rather than amplification. A negative gain is thus equivalent to an attenuation (or loss). If desired, the formulae may be adapted to produce a positive result for attenuation simply by inverting the ratios, as shown below: where Ap, Av, or Ai is the power, voltage or current gain (or loss) expressed in decibels, Pin and Pout are the input and output powers, Vin and Vout are the input and output voltages, and Iin and Iout are the input and output currents. Again note that the powers, voltages or currents should be expressed in the same units/multiples (e.g. Pin and Pout should both be expressed in W, mW, µW or nW).

DOI: 10.4324/9780080941523-141