Research work · 2024

Visualization Analysis of Wrinkle Generation Phenomenon of PP Decorative Sheets in In-mold Injection Molding (Part 3) ―Verification of Wrinkle Generation Model by Calculation of Amount of Deformation in Decorative Sheet in the Flow Direction―

Kaname Kondo, Hidetoshi Yokoi

Seikei-Kakou

Abstract

When conducting in-mold injection molding, wrinkle formation on decorative sheets is a problem faced during the resin filling process. In our previous papers, through visualization analysis, we showed that the sheet deforms elongationally in the flow direction. Moreover, we also identified the interfacial thermal resistance of each interface during in-mold injection molding using our developed method of measuring temperature inside the sheet and temperature of the flow front resin contacting the sheet. In this paper, we calculated the time at which sheet deformation stops by comparing the results of calculating frictional force derived from perpendicular force imposed on the sheet and elongation force in the flow direction derived from shear stress and thermal stress. The calculated and measured results showed good agreement with each other, confirming that the deformation of the sheet stops after some time from the passing of the flow front because the sheet is fixed to the cavity surface by the frictional force, which suppresses the elongation and deformation in the flow direction. Furthermore, we showed the sheet deformation model during in-mold injection molding by comparing the calculated and measured deformation amount of the sheet. While the perpendicular force did not increase to fix the sheet on the cavity surface, the sheet slipped on the mold surface and deformed due to thermal expansion and shear stress. After the frictional force derived from the perpendicular force increased enough to fix the sheet onto the cavity surface, the sheet deformation stopped. Based on the sheet deformation model, we proposed solutions to reduce wrinkling of the decorative sheet from the perspectives of thermal expansion, deformation stress, and frictional force.

Download PDF

DOI: 10.4325/seikeikakou.36.166